CREATON storm clips

We have the right clips for every storm protection situation. You can secure our entire clay roof tile product range against wind uplift with only three standard and three special clips. Our application technology team has prepared a clearly arranged table so you can quickly and easily identify which clip you need for which of our products.

Secure roof covering due to proven products

The following table shows which clips are approved for which CREATON tiles. If you have technical questions, please contact our application technology team by phone +49 (0) 8272 / 86 533 or by email anwendungstechnik@creaton.de.

 

 

Hanger clip

The clip is pushed through underneath the batten and hooked onto it and fastened in the side groove with the long leg. The lower left hand tile is not shown here but should be covered beforehand.


Drive in clip

The clip is driven into the carrier batten with the nail and attached to the side groove by the U-shaped leg.


Plain tile clip

The clip is attached by passing it under the batten from above. The T leg holds the tile firmly from above.


Special clip „ANTICO“

Both clip hooks are hooked into the head and side grooves of the two tiles where the 4 tiles meet and the nail is driven in.


Special clip „ROMANO“

Both clip hooks are hooked into the head and side grooves of the two tiles where the 4 tiles meet and the nail is driven in.


Special clip for „PROFIL“ side interlock tile

Both of the clip hooks are hooked into the lateral interlocking joint and set down on the head area of the side interlock tile below. The nail is then driven in.